facebook linkedin youtube
National Unified Hotline :

+86 152 0377 6376

Email Us :

gm@geostarpe.com

#Language :

EnglishEnglish

内页banner

Search

Home

Geothermal Drilling Mud Pump

  • Installation of Drilling Mud Pump
    Installation of Drilling Mud Pump
    Oct 22, 2023
    Drilling mud pump is the core equipment for petroleum drilling rig package, and following is the installation procedure of drilling mud pump unit. 1. The drilling pump and the base must be placed on a horizontal basis, the pump should be kept as horizontal as possible, and the horizontal deviation should not exceed 3mm, in order to facilitate the correct distribution of lubricating oil at the power end during operation.   2. The position of the pump should be as low as possible, and the position of the drilling mud tank should be raised as much as possible to facilitate suction.   3. The inner diameter of the suction pipe of the pump shall not be smaller than the inner diameter of the connection part of the pump. Before installation, it is necessary to clean the pump suction and pipelines, the suction line must not have air leakage, valves and elbows should be installed as little as possible, valves must use full-open valves. The length of the inlet pipe should be kept within the length range of 2.1m~3.5m to reduce the friction loss and inertia loss in the suction pipe, which is helpful. For suction, the suction line should be 300mm higher than the bottom of the drilling mud tank.   4. In order to smooth the operation of the pump and extend the life of the wear parts, the drilling pump needs to be equipped with a super charging pump. Between the inlet of the pump and the outlet of the charging pump. There should be a safety valve, which is adjusted to 0.5MPa, which protects the charging pump from damage in the event of overpressure in the suction pipe.   5. The connection between the suction pipe and the drilling mud tank cannot be directly opposite the drilling fluid return point above the drilling fluid pool, so as not to suck the drilling fluid tank bottom debris.   6. Firmly support all suction and discharge lines so that they are not subjected to unnecessary stress and reduce vibrations, which must never be caused by. There is not enough support to allow the line to hang on the pump.   7. In order to prevent damage to the drilling fluid pump due to excessive pressure, the relief valve must be installed at the outlet near the pump, and the safety valve must be installed before any valve, so that if the pump is accidentally started when the valve is closed, and the pump will not be damaged, the relief valve must be installed. The seamless steel pipe for the outlet is led directly to the mud pool, and this seamless steel pipe should have as few turns as possible. If turning, the elbow should be larger than 120°, do not lead the discharge end of the safety valve to the suction pipe of the pump with a pipe, so as to avoid high-pressure drilling fluid drainage when the safety valve is opened out causing unnecessary accidents.
    Read More

Leave A Message

Leave A Message
If you are interested in our products and want to know more details, please leave a message here, we will reply to you as soon as we can.
Submit

Home

Products

whatsApp

contact